Tool steel plate from 2 mm THYRAPID THYRODUR THYROPLAST THYROTHERM Very close to the finished size Cut a bett With tool steel p Optimising material selection As a result of their high quality and the wide range of individual alloying options, tool steels from Edelstahl Witten-Krefeld are the materials of choice for many demanding industrial tool applications. Anyone who specifically selects the material on the basis of the requirements imposed on the tools, can expect significantly longer service lives. The higher production quantities and short cycle times can substantially reduce the cost per unit. Our materials specialists have comprehensive know-how and extensive experience with applications. So, ask for our advice even during the planning phase in order to find the most advantageous solution in every case. You’ll find that EWK’s consulting service pays off for you. Reducing material input As of now, our tool steels are also available in plate thicknesses – from 2 mm upwards. The plates are cross-rolled with very close tolerances. Their characteristics include a non-directional microstructure, almost no dimensional changes during hardening, and uniform mechanical/technological properties. We can supply plate material in the following forms: descaled, inert-gas annealed, sheared, sawn, straightened and, on request, shot-blasted. Using our steel plate from 2 mm upwards gets you closer to the finished size. You reduce the material input and lower the tool production costs. Tool steel plate for the production of cutter blades, circular saw blades, precision flats, components ... ter figure. plate from 2 mm. In plate thicknesses from 2 mm: Cold-work steels Thyrodur 2379 Thyrodur 2080 Thyrodur 2436 Thyrodur 2363 Thyrodur 2842 Thyrodur 2510 Thyrodur 2241 Thyrodur 2767 High-speed steels Thyrapid 3343 Steels for plastic moulding Thyroplast 2311 Thyroplast 2312 Thyroplast 2085 Thyroplast 2162 Hot-work steels Thyrotherm 2343 Thyrotherm 2344 Other tool steel grades on request Width: Up to 2,000 mm Length: 1,500 – 4,000 mm Other formats on request Note: Plate thicknesses of 2.0 – 2.2 mm are only available with a plus tolerance. All other thicknesses can also be supplied with plus/minus tolerances, or only with a minus tolerance. Closer to the finished size, closer to a profit. Auestrasse 4, D-58452 Witten/Germany Tel. +49 (0)2302/29-4357 · Fax +49 (0)2302/29-4237 verhoeven@tks-ewk.thyssenkrupp.com www.edelstahl-witten-krefeld.de 10/2004C General note (liability) All statements regarding the properties or utilisation of materials or products mentioned are for the purposes of description only. Guarantees regarding the existence of certain properties or a certain utilisation are only ever valid if agreed upon in writing. Tool steel plate from 2 mm THYRAPID THYRODUR THYROPLAST THYROTHERM Very close to the finished size