1. No category

FACE FIX SPIRAL KIT
Tambour Door
Installation Guide
Face Fix Spiral Kit
Beech, Black, Bronze, Silver
This kit can easily be installed in a pre-assembled cabinet.
1) First mark out the position of the runner and the spirals. You can fix the
runner up to the edge of the cabinet, or behind a face panel with an
opening cut through.
2) Fix the spiral into position on both sides. You will need to drill and
countersink holes into the spiral for screw fixing . A good quality double
sided tape could also be used to fix the spiral into place.
TIP: If drilling make sure the screws sit flush with the runner to avoid
fouling the door.
3) The cabinet needs to be assembled before the next stage.
4) Carefully slide the assembled tambour door into the spirals until fully in.
5) Cut the straight runner to length and fix into place. You will need to drill
and countersink holes into the runner for screw fixing . A good quality
double sided tape could also be used to fix the runner into place.
TIP: If drilling make sure the screws sit flush with the runner to avoid
fouling the door
6) If you are installing the door with the slats vertical so the door operates in a
horizontal direction.
TIP: Apply the supplied self-adhesive magnetic strip to the door edge and
the cabinet. This will prevent the door from opening whilst travelling.
7) If you need to reduce the height of the door, cut back the cotton tape from
the top and remove the required number of slats.
8) If you need to reduce the width of the door, simply cut the slats carefully
using a fine tooth saw.
9) TIP: Apply some Petroleum Jelly (e.g. Vaseline) or Candle Wax in the
runner, this helps for smooth operation.
IF YOU ARE UNSURE OR NEED ANY ADVICE, PLEASE CONTACT US
MG Design
Unit 27a, Desborough Lane, Plymouth. PL4 9PJ
Tel: 07875575662 Email: info@mgdesign.biz
www.mgdesign.biz
facebook.com/mgdesign.biz