1. No category

How to wire a PTZ camera to your AVTech DVR
For Model(s): VC-SYS-4WEBMVPB/VC-SYS-8WEBMVPB/VC-SYS-16WEBMVPB
V 1.1
By AGI Security Technical Department
To connect your PTZ camera(s) to your AVTech dvr, you must locate the External I/O port on the back of the DVR.
See Figure 1.
Figure 1 (Example of a 4 CH DVR)
Use the following diagram to connect your PTZ camera wires. Note. It’s suggested you use a DSUB 9 (for 4 CH) or
DSUB 25 (for 8 and 16 CH) pin connector to hook up your PTZ wire. The DSUB 9 connector is not included with the
4 CH DVR.
How to wire a PTZ camera to your AVTech DVR
1
Diagram for an 4 CH DVR
Diagram for an 8 and 16 CH DVR
How to wire a PTZ camera to your AVTech DVR
2