1. No category

How to cut the HHG50 & HHG100 SMD LED Task Light to a custom size
These lights can be cut every section of 3 chips as shown. There is a pair of chips with a black
mark between them followed by a single chip. The pattern then repeats over the length of the
light. A straight cut between the chips as shown will allow you to cut these lights to any size
required. There is a small black dot which indicates the cut line on the strip light.
The lights are easy to cut using a miter box and a hacksaw to ensure a straight cut. End caps,
gasket and screws are provided to finish the cut lights. The cut piece you have left is also a
working light and can be used elsewhere.
CAUTION: If you cut in the wrong place you will damage the circuit board and the light will not
light. Move on to the next set of 3 chips as shown and cut again. LED Lights Canada assumes
no liability for cut lights that are damaged by incorrect cutting of lights. LED Lights Canada will
pre cut your lights to dimensions provided by you for a nominal fee per light.
If you have any questions or concerns about cutting the light please give us a call at
780.993.8735 or toll free at 1-800-677-2698.
Enjoy your new lights!
LED Lights Canada
800-677-2698
info@ledlightscanada.com
www.ledlightscanada.com
1