Download Report

PRODUCT INTRODUCTION
User manual
ORCATORCH ES10 is an ultra-compact EDC LED flashlight with easy
operation by side switch. It adopts the latest USA Cree XM-L2(U2) LED,
offers three brightness levels, one hidden rapid strobe mode, max 360
lumens output, runtime up to 28 hours, which provide a perfect
combination of high brightness and long runtime. User friendly side
operation switch, ultra-compact size and IPX-6 standard waterproof, all
these features make ORCATORCH ES10 a perfect EDC flashlight for
self-defense and various outdoor activities such as camping, hiking,
fishing, etc.
Notice: Stated data has been measured according to the international flashlight
test standards ANSI/NEMA FL1 using one CR123A battery(3V,1300mAh) under
laboratory conditions. The parameters are approximate and may vary between
flashlights, batteries, and environments.
OPERATION INSTRUCTIONS
1. Press the side button to turn the flashlight on at low brightness mode,
continue to press the button to switch mode among low, middle, high.
2. When the flashlight is on, keep pressing the button for 3 seconds to
get the hidden rapid strobe mode, and press again to get back to the
previous mode.
3. When you don't use it, please unscrew connection of flashlight head
for energy saving.
PRODUCT FEATURES
Cree XM-L2(U2) LED, max 360 lumens output
Uses 1*CR123A / RCR123A /16340 battery, ultra-compact size
Easy operation by side switch
High efficiency constant current circuit, constant brightness
Anti-roll, slip-resistant body design
Aircraft-grade high strength aluminum AL-6061-T6 with premium
Type III military hard-anodized anti-abrasive finish
Alloy aluminum reflector with professional optical analysis
Toughened glass with anti-reflective coating
Side switch
BATTERY REPLACEMENT
Output
Runtime
Beam
Distance
Intensity
Impact
Resistant
ES10
Max
360 Lumens
Waterproof
Working voltage
Dimension
High
Middle
Low
Strobe
360 Lumens
100 Lumens
10 Lumens
360 Lumens
1h20min
3h45min
28h
/
113m
3200cd
1m
IPX-6
damage to the flashlight and will void the warranty.
²
We recommend the use of high quality batteries. If the flashlight will
not be used for a long time, remove the batteries to avoid damage from
electrolyte leakage or battery explosion.
²
Please replace the O-rings if they are damaged after prolonged use
and regularly lubricate the o-rings so as to not erode the rubber. Doing
so will keep the flashlight properly sealed against water.
²
Please clean the contacts of your light from time to time, especially
when the light flickers or doesn't light up. There are probably several
reasons for a flickering or not working light:
Reason A: The batteries need to be replaced.
Solution: Replace batteries (Please confirm correct installation of +
and - terminals).
Reason B: The threads, PCB board contact or other contacts are dirty.
Solution: Clean the contact points with an alcohol soaked cotton swab.
If the methods above don't work, please contact the distributors and
refer to the warranty policy.
PRODUCT WARRANTY
Rotary
TECHNICAL PARAMETERS
ANSI/NEMA FL1
USAGE AND MAINTENANCE
²
Please don't disassemble the sealed head, doing so may cause
1. As shown in the figure, insert the battery with the anode side (+)
toward the light head.
2. Please do not reverse the battery to avoid damage to the flashlight
and battery.
3. Please do not use battery with higher voltage than the flashlight
working voltage.
4. Please do not use battery with damaged surface or deformation to
avoid short circuit, explosion, leakage, etc.
We will replace products afflicted with manufacturing defects within 30
days of purchase and repair a light free of charge within 24 months of
purchase if problems develop under normal use; if repair is required
after 24 months from the date of purchase, we will charge for parts. The
total repair fee is dictated by the cost of the replaced materials.
Warning
The flashlight is high intensity lighting device and capable of causing
eye damage, please avoid shining the light directly into the eyes.
0.9 – 4.2 V
72mm(Length) x 24mm(Diameter)
Net weight
37g（excluding battery）
Accessories
Key chain, O-ring, lanyard
ORCATORCH TECHNOLOGY LIMITED
Tel:+86-755-33560383
Fax:+86-755-29454989
Email: info@orcatorch.com
www.orcatorch.com
Address: 7F, Building 6, Yusheng Industrial Park,
Gushu, Xixiang, Baoan, Shenzhen, China (518102)
Patent No. 201230361008.2 All Rights Reserved
www.orcatorch.com