1. No category

W F L Y 2. 4G 4 096 P CMS O perat i o n i n s t ructi o n s
2.4G system can automatically recognize WFLY PCM s and PPM.
1 . Code mat c h i n g
A. Pre s s S e t t o s t a r t t h e r e c e i v e r . T h e o r a nge LED flashes, indicating the receiver waits for t he
code m a t c h i n g s i g n a l .
Flash
The same setting for WFR07S and WFR09S
B. Hol d S E T o f t h e m o d u l e , t h e n p r e s s P o w e r to start the transmitter. Press SET again to enter t he code
match i n g f u n c t i o n . T h e o r a n g e L E D o f t h e r e c eiver lights up. Press SET and hold until the oran ge LED
flash e s , i n d i c a t i n g t h e r e c e i v e r e n t e r s t h e code matching status.
Fail safe set
Code matching
C. If the code matches successfully, the green LED of the transmitter lights up.
The LED of the receiver is off.
2. Operation Instructions
The receiver is on. The red LED lights up. Wait for the powering up of
the transmitter .
T h e r e ceiver is on. The green LED of the transmitter lights up.
T h e L E D of the receiver is off.
3 . Fail Safe S e t t i n g
A.Pow e r o n r e c e i v e r .
B.Press Set of the module then start transmitter and hold SET for 2 seconds. T he green LED flashes,
indicating the transmitter enters the code matching status.
C. The G re en L E D of r e cei ve r fl ash es , th e output data of transmitter is the d ata o f Fail Safe Setting of
the re cei ve r.
D. Due to the heavy interference or out of normal range, the receiver enters FailSafe. The Red LED of the
receiver lights when it is in Fail Safe status .