1. No category

RBS
ROD BUILDING SYSTEM
RBS Package Contents:
RBS-ABS: Aluminum Base Station (3)
RBS-SLAT Connecting Slat Packs (2)
Contains:
• S.S. Connecting Slats (4)
• Slat Screws (8)
• Lock Washer (8)
• Nut (8)
RBS-ROLLER Bearing Kits (2)
Contains:
• Aluminum Track Bearings (6)
• Concave Bearing Washers (12)
• Bearing Screw (6)
RBS-TBOLT Sliding Mounting Bolt (3)
Contains:
• T-Bolt (3)
• Washer (3)
• Wing Nut (3)
1A
1B
Botto
m
Bottom
Locking Washer
Nut
Bottom
Bolt
1. Connecting the RBS-ABS
Aluminum Base Stations
(Tools Needed: Phillips Head Screw
Driver)
1A.) Align the S.S. Slat with the holes
located on each end of each
Aluminum Base station. Attach the
slat to the bottom side of each end
connecting the bases as shown
1B.) Mounting order: Screw >
Aluminum Base Stations > Slat >
Lock Washer > Nut
1C.) Repeat steps for remaining slats
and Base Stations.
2. Attach the RBS
Rollers to HWS-1
2A
2A.) Locate the (6) mounting
holes found on the bottom of
the HWS-1
2B.) Bearing should be
mounted in this order shown
to the right.
2C.) Tighten the roller
assembly until it’s flush with
the mounting location on
HWS-1 (do NOT overtighten)
then back the screw out two
complete rotations. This will
allow the bearings to travel
smoothly once in the track.
Bearing
Washer
Screw
2C
2B
Bearing
3. Line up the bearings mounted on
the HWS-1 with the roller tracks on
the ABS.
3A.) The lip of the dual ABS track should travel
in the grooves of the roller bearings. Carefully
align both sets of bearings while inserting into
ABS.
4A
3A
4B
4. Mount Support Stands and other CRB
Tools using the RBS-TBolts
4A.) The T-Bolts are specifically designed to work with the
center track located on the ABS. Insert T-Bolt and turn 90
degrees to lock.
4B.) Attach your support stands and other tools once the t-bolt
is locked in place using the included wing nut and washer.
Check out our
videos for rod
building
instructions:
Questions? Call us at (866)
790-RODS for expert support or visit
our forums at forums.mudhole.com
The CRB
RBS Works
With These
Great CRB
Products:
Rod Dryer
Spine Finder
Epoxy Mixer
Laser Alignment
Power Head