www.dewetron.com How to set DEWESoft Default Setup After installing DeweSoft, please create a folder „Data“ on Data Partition ( D: ). After this, please start DeweSoft and follow the instructions. Select the Hardware you want to use and registrate the Software in the Licensing menu. Page 1 of 8 DEWETRON SERVICE MANUAL © DEWETRON Ges.m.b.H June 12, 2006 www.dewetron.com Please select all channels and change the Dynamic Acquisition Rate to 10.000 Hz. With the little arrow next to „Hz/ch“ you can select „kHz/ch“, so you get a better overview (This can be seen in the picture below). Page 2 of 8 DEWETRON SERVICE MANUAL © DEWETRON Ges.m.b.H June 12, 2006 www.dewetron.com Overview: Click at the Digital Display and then change the Display type from Actual to Average. After this please de-select the Design-Mode by clicking at the „Design“ button. Page 3 of 8 DEWETRON SERVICE MANUAL © DEWETRON Ges.m.b.H June 12, 2006 www.dewetron.com Scope: At the scope screen please deselect all channels except channel „AI 0“. And after this, also de-select the Design-Mode by clicking at the „Design“ button. Page 4 of 8 DEWETRON SERVICE MANUAL © DEWETRON Ges.m.b.H June 12, 2006 www.dewetron.com Recorder: At the Recorder Screen you are able to see the channels you have selected at the Setup screen, but the problem is that you only can show four channels in one part of the Recorder. So if you click the Recorder Screen when Design-Mode is active you can click at the „+“ to add more Recorder to the screen. You can also add a complete new Recorder screen when you go to the menu-point Displays and click at „Add display“. Please make sure that you de-select the Design-Mode by clicking at the „Design“ button at least. Page 5 of 8 DEWETRON SERVICE MANUAL © DEWETRON Ges.m.b.H June 12, 2006 www.dewetron.com Now the Screen Setting is ready and we can save the Setup. Click at File and Save Setup and then save it as „default“. After saving the default-setup, please go to the menu point „System“ and Select „General Setup“, shown in the picture below. General Settings: At the first page you can select your language and the Starting directory for storing data. The starting directory for storing data please change to „D:/Data“ shown in the picture below. If you want to change the language you have to restart DeweSoft. Page 6 of 8 DEWETRON SERVICE MANUAL © DEWETRON Ges.m.b.H June 12, 2006 www.dewetron.com At the next step we will set the „Starting setup“. To select the file which will be loaded when DeweSoft gets startet, Click at the button „ ... “ ( next to AutoLoad ) you can see it at the pictures below. Page 7 of 8 DEWETRON SERVICE MANUAL © DEWETRON Ges.m.b.H June 12, 2006 www.dewetron.com Now you have set the DeweSoft-default factory settings. Next step is to make a setting in the DeweSoft Tuner. If you have selected a difference language at the DeweSoft-General setup please select here the right characters for your language. If you have any questions about how to set DeweSoft Default setup, please contact us. DEWETRON Andreas Schaumberger +43-316-3070-246 andreas.schaumberger@dewetron.com Page 8 of 8 DEWETRON SERVICE MANUAL © DEWETRON Ges.m.b.H June 12, 2006