BWT PERMAQ® Pro Duo 250 - 1000 Product data sheet 09/2014 Double-pass reverse osmosis system Bacteria-free and clean water for demanding requirements Benefits: Ultra-clean water in accordance with DS/EN 285 Water quality <5 µS/cm w/NaOH dosage Retains microorganisms such as bacteria and pyrogens Flow meter for direct reading of permeate and concentrate capacity If there is no water supply (low inlet pressure) the system switches off automatically High capacity per membrane Conductivity meter fitted with the option of an alarm Dosage of lye (NaOH) between 1 and 2 pass to bind the released CO2, whereby the water quality nd after the 2 pass improves st nd Bacteria-free and safe water quality Features: Letting the water pass through a single membrane already creates good water quality. Unlike a conventional reverse osmosis system, the DUO series takes the filtered water through another membrane nd filtration (2 pass) to remove even more of the few remaining salts in the water. Ultra clean water using double-pass reverse osmosis Automatic stop of the system, if the inlet pressure is too low This process creates extraordinarily clean water, which meets the specifications for water in DS/EN 282 – water for sterilisation, steam autoclaves, large autoclaves, etc. Hospitals, laboratories and sterilisation centres Typical application areas: Autoclaves Evaporators Chemical industry Laboratories Humidifiers Process water BWT HOH A/S Geminivej 24 • DK-2670 Greve Tel.: +45 43 600 500 bwt@bwt.dk • www.bwt.dk Der tages forbehold for trykfejl og tekniske ændringer. BWT PERMAQ® Pro Duo 250 - 1000 Product data sheet 09/2014 Double-pass reverse osmosis system Technical data: ® Unit Duo 250 Duo 500 Duo 1000 Nominal permeate performance * l/h 250 500 1000 Water utilisation WCT max. ** % 75 Salt reduction % > 98 Water quality µS/cm <5 BWT PERMAQ Pro Duo Electrical connection Installed power V/Hz 3x400/50 kW 2.2 4.0 ” 3/4 Outlet diameter mm 12 Drain diameter mm 12 Dynamic inlet pressure, min./max. bar 3/7 Width mm 1150 Depth mm 650 Height mm 1720 Inlet diameter Product number 421071730 Reservoir and pump 421071740 Option Softening filter Option * For water quality of: 10°C, 3 bar, TDS ≤ 500 mg/l ± 15%, SDI ≤ 3.0%/min, oxidants ≤ 0.05 mg/l. ** Based on a water quality of TDS ≤ 500 mg/l, without softening as a pre-treatment. BWT HOH A/S Geminivej 24 • DK-2670 Greve Tel.: +45 43 600 500 bwt@bwt.dk • www.bwt.dk Der tages forbehold for trykfejl og tekniske ændringer. 421071750
© Copyright 2024